Below are the new additions to the dashboard for the week of March 14, 2022.
1. When in maintenance mode you can temporarily disable alerting for a sensor.
Custom Sensor pages were also created for the following sensor types:
- NCD Vibration and Temperature
- NCD Predictive Maintenance Sensor v2 (Vibration, Temperature, and Amperage)
- NCD Predictive Maintenance Sensor v3 (FFT Capable)
- NCD One Channel Vib+ (FFT Capable)
- NCD Environmental Air Quality
- NCD One Channel AC Current
2. You can now upload up to 10 photos using the three dots to the right under current sensor health.
3. You can now adjust thresholds using the three dots to the right under current sensor health. This includes drag and drop threshold setting by adjusting the sliders on the graph.
4. A high level overview display for locations showing all events and devices located at the top of the side navigation.
5. On the events page you can now choose between a table view or card view. Also selecting an event from the table will open the full page event view.
6. The full event page now includes graphs of when the event occurred. On this page you can change the event state and add notes.
7. In the devices tab on the asset page a threshold button has been added for viewing each.
8. You can now see the percent change over the last 24 hours down to the sensor level by clicking down through the tree map.
9. Sub-location pages now use the same format as the company and location pages.
10. Additional Sensor transmission info has been added under devices page. All device information shown in the table can be exported to excel.
Back-end Changes
- 24 hr availability workflow- You can now configure the threshold globally at a company level, or a device level. Management of this feature will be added in the coming releases.
Next Release Notes 6.6
0 Comments
Add your comment