• Compatible with Gas, Liquid, or Vapor.
• Issues automated warning in the event of bearing or lubrication failure.
• Identifies steam trap issues and valve leakage
• 2-mile communication range between sensor and gateway

• Temperature Operation Range  -30°C to +80°C
• Operating Range 0.500 mA DC to 16.280 mA DC @ 0.158 mA/dB of Change in Detected Ultrasonic Signal
• Accuracy ±0.5%FS (pressure)  ±1.5℃ (Temperature)
• Sampling Frequency 1.5ms
• 10/32 UNF Mounting Hole
• CE/UKCA Certified
• Water and Dust Proof Enclosure (IP67) NEMA 6p

Power Supply Voltage- 23 to 26 V, DC power source @ 30

• Wireless Frequency 900MHz
• 128bit AES encryption  
• Sensor: 6.5"L x 4.25"W x 3"H
• Sensor Weighs 1.6 lbs
• Gateway: 13.75"L (with antennae) x 5.5"W x 2.5"H
• Gateway Weighs 1.15 lbs

• Bearing Condition Monitoring and Lubrication
• Valve and Steam Trap Monitoring

• Prepare the mounting surface.
• Mix the 2-part epoxy using the instruction included with the kit and apply.
• Press on the plastic piece of the mounting kit until it clicks.
• Wait 10 – 15 minutes.
• Remove the plastic mounting kit from the stud.
• Thread the sensor onto the stud.

See below for an example:  

Motor Fin Mount

• Measure the depth and width of cooling fan to select the proper Motor Fin Mount.
• Verify the Motor Fin Mount is long enough to make direct contact with the motor case between the fins.
• Add LOCTITE AA HH3300 adhesive is then used to hold the mount in place.

The thickness of the mount will minimize the amount of adhesive needed.